The best deal to get for your Gauntlet or Gauntlet 2 is our Short Shroud Combo. It includes the short shroud, air stripper, and then you select the suppressor of your choice.

https://donnyfl.com/products/gauntlet-and-tatsu-package-deal?_pos=1&_sid=aec26c034&_ss=r


If you want to buy separate here is the links below.

You will need this adapter.

https://donnyfl.com/products/gauntlet-1-2-x-20-adapter?_pos=3&_sid=aec26c034&_ss=r


Aluminum air stripper

https://donnyfl.com/products/gauntlet-aluminum-air-stripper?_pos=2&_sid=aec26c034&_ss=r


Short shroud

https://donnyfl.com/products/gauntlet-short-shroud-with-1-2-x-20-adapter?_pos=4&_sid=aec26c034&_ss=r


For a .22 I recommend the Sumo .22/.25 1/2x20 #S61 option

https://donnyfl.com/collections/ldc/products/1-5-x-6-5-inch-sumo?variant=33070855487531


For a .25/.30 I recommend the Sumo .25/.30 1/2x20 #S9 option.

https://donnyfl.com/collections/ldc/products/1-5-x-6-5-inch-sumo?variant=37719183748


Gauntlet 2 .30 caliber
Our go-to recommendation for the Gauntlet 2 in .30 is the #S18 Ronin. Anything smaller is not enough to tame the muzzle report.
https://donnyfl.com/collections/ldc/products/2-x-6-5-inch-ronin?variant=41534539652

We have heard about a few .30 cal Gauntlet 2's where customers have experienced clipping. The Gauntlet 2 1/2x20 UNF thread adapter that comes with the rifle is very well designed, and the risk of this is minimal as long as you check the following. Make sure that both the inner and outer o-rings are properly installed on the adapter. This should center the barrel and alleviate any clipping issues. When you install the adapter make sure the shroud is fully seated and screwed in to the action.


The other possible culprit is an improperly crowned barrel, or a pellet with a badly deformed skirt.


If you have reason to be concerned that your airgun might be prone to clipping we recommend the .357 version of the Ronin, the #S21, but with a 1/2x20 UNF thread endcap. You can put the note in your order and we will swap that endcap for you before we ship it out. Just tell us you need the 1/2x20 UNF thread endcap for your Gauntlet 2.

This will help avoid clipping but still provide good noise suppression of your airgun.

https://donnyfl.com/collections/ldc/products/2-x-6-5-inch-ronin?variant=13286078251051